Jet SPACE BALLZ - Entering System Setup

PROGRAM SETUP INFORMATION
Step # 1
Locate the keypad inside the control center
Step # 2
Entering the software
Step # 3
Checking the installed software version
Open the ticket access door and look towards the left of the
ticket storage bins. Locate the keypad. The keypad is
connected to the PC through a USB cable. Ensure that the
"green" indicator light on the keypad is illuminated. The
illuminated light is your indication that the keypad
connection is proper and that it is recognized through
Windows.
On the keypad, push and hold the plus ( + ) button. Keep
holding the button down and the game should enter the
software mode after a few seconds. Notice: You must push
and hold the button in order to enter the software mode.
Pushing the plus (+) button only once will not enter the
software.
You will recognize that you have entered the software by
looking at the SEG displays along the bottom of the playfield.
While in the software mode, the software version will be
displayed along the nine SEG displays.
Current Game Software Version
2 0 1 1 0 4 1 6. A
Notice: Always check our website for the most current
software version available.
Jennison Entertainment Technologies Space Ballz Service Manual Page 37