PROGRAM SETUP INFORMATION
You can adjust the volume of both the Attract Mode and the
Game Mode Volume. The settings are from 0-10, with 10
being the highest. In a noisy arcade setting, we suggest you
leave both volume levels at 10. Please note that volume can
also be adjusted on the subwoofer itself by turning the
volume knob. To change either value, press the "ENTER"
button and then select the desired level using the numeric
keys on the keypad.
Exiting the software - continued
After changing any value within any of the pages, you can
EXIT the software by pushing and holding the minus ( - )
button. Continue to hold this button until you see the screen
exit and the JET logo. The game will then re-start. It takes
about 2 minutes to fully re-start the game. During this time,
you may see video on the monitor, but the game will not be
ready to play until the unit finishes its diagnostic process.
You will see the game load both the Bonus Score State Values
and then the Game Score State Values before finishing the
diagnostic process. After all lights turn BLUE and then begin
to cascade, the game is then ready to play.
Your indication that you have successfully exited the game
software menu will be that the screen will initially show the
JET company logo. When you see this screen - release the ( - )
button.
Jennison Entertainment Technologies Space Ballz Service Manual Page 45
To Next Page
Loading...