To Next Page
J
Jason WileyNov 19, 2025
What to do if the blade wanders during cut or makes out-of-square cuts with my Jet VBS-18MW?
- KKathleen JohnsonNov 19, 2025
If the blade of your Jet Saw wanders during a cut or produces out-of-square cuts, several factors could be responsible. Begin by checking and adjusting the fence to ensure it's aligned with the blade. If the wood is warped, select another piece. Gum or pitch on the blade or table can also cause this issue, so clean as needed. An excessive feed rate can contribute, so reduce it. Ensure you're using the correct blade for the cut. Verify and adjust the blade tension according to the blade size. Make sure the blade guide assembly is not loose and tighten if necessary. Review the guide bearing adjustment; if the bearings are worn, replace them. Replace the blade if it is dull. Also, ensure that you are using the correct blade speed. Finally, adjust the tracking if the blade is not tracking prop...
General
