Jet JWBS-15 User Manual

Operating Instructions and Parts Manual
Woodworking Band Saws
Model JWBS-15, JWBS-18, JWBS-20
JET
427 New Sanford Road
LaVergne, Tennessee 37086 Part No. M-714600
Ph.: 800-274-6848 Edition 5 09/2018
www.jettools.com Copyright © 2017 JET
JWBS-20 shown
For serial nos.:
JWBS-15: 17120226 and higher
JWBS-17: 18030001 and higher
JWBS-18: 17110021 and higher
This .pdf document is bookmarked

Jet JWBS-15 Specifications

General

Type	Bandsaw
Cutting Capacity Width	15 inches
Blade Speed	3000 FPM
Blade Width	1/8 to 3/4 inches
Motor Power	1.75 HP
Table Tilt	10° left, 45° right
Voltage	115/230V

Summary

Important Safety Instructions

General Safety Guidelines

Essential safety precautions for operating the band saw to prevent injury.

Specifications

Setup and Assembly

Assembly Procedures

Step-by-step instructions for handwheel installation and table mounting.

Fence Assembly and Alignment

Electrical Connections

Grounding Instructions

Critical safety information on proper grounding to prevent electrical hazards.

1.75HP Model Connections

3HP Model Connections

5HP Model Connections

Adjustments

Table and Fence Adjustments

Procedures for adjusting table tilt, 90-degree stop, and fence alignment.

Blade Installation and Tensioning

Steps for safely installing, tensioning, and changing saw blades.

Blade Tracking

How to properly track the blade for accurate and safe cutting.

Guide Bearing Adjustments

Instructions for setting upper and lower blade guide bearings for optimal performance.

Operation

General Operating Procedures

Basic steps for safe and effective band saw operation.

Cutting Techniques

Blade Selection Guide

User Maintenance

Routine Cleaning and Lubrication

Blade Selection Guide

Material and Thickness Recommendations

Troubleshooting

Operational Problems

Solutions for common issues like table not tilting or rough surface finish.

Mechanical and Electrical Problems