To Next PageTo Next Page
Need help?Do you have a question about the Jet JWBS-140S and is the answer not in the manual?
General| Type | Bandsaw |
|---|---|
| Motor Power | 1 HP |
| Blade Speed | 3000 FPM |
| Blade Length | 93.5 inches |
| Blade Width | 1/8 to 3/4 inches |
| Table Size | 15 x 15 inches |
| Cutting Height | 6 in |
| Cutting Width | 13.5 inches |
| Voltage | 115V |
| Cutting Capacity at 90° | 6 in |
Details what the warranty covers, excluding consumables like cutting tools and abrasives.
Specifies that the warranty applies only to the original purchaser of the product.
States that the warranty duration is as specified in the product literature.
Lists exclusions, including commercial use for certain warranties and misuse, wear, or lack of maintenance.
Outlines the process for obtaining warranty service, including return and inspection procedures.
Mentions that warranty grants specific legal rights, which may vary by state.
Disclaims implied warranties and limits liability for incidental or consequential damages.
Covers essential safety rules for operation, including reading the manual, using PPE, and proper machine setup.
Warns about dust hazards and chemical exposure, recommending ventilation and masks.
Emphasizes undivided attention, proper stance, using correct tools, and keeping the work area clean.
Instructs on safe cleaning procedures, blade handling, and securing the workpiece.
Explains the meaning of 'CAUTION' and 'WARNING' labels used in the manual.
Lists all components included in the shipping carton, with item numbers and quantities.
Details the fasteners and hardware included for assembling the saw body.
Lists hardware included for assembling the stand structure.
Specifies the tools needed to assemble the band saw and its stand.
Provides step-by-step instructions for assembling the band saw stand, referencing Figure 1.
Guides on how to unpack the saw, inspect for damage, and check contents against the list.
Instructions for loosening knobs, tilting the table to desired angles, and re-tightening.
Procedure for setting the table stop to ensure accurate 90-degree alignment with the blade.
Steps for safely removing and installing new saw blades, including tensioning and wheel covers.
Details on how to properly tension the saw blade using the tension knob and gauge.
Procedure for aligning the blade to track correctly in the center of the wheels using the tracking knob.
Continuation of the parts list for the JWBS-14OS band saw body assembly.
Final section of the parts list for the JWBS-14OS band saw body assembly.
Electrical schematic for the 115-volt operation of the band saw, showing wiring connections.
