To Next PageTo Next Page
Need help?Do you have a question about the Jet JWBS-18 and is the answer not in the manual?
Essential safety precautions and warnings for operating the band saw.
Overview of the manual's scope, intended use, and information provided.
Details technical specifications and capacities for different band saw models.
Technical data and measurements for the JWBS-15 band saw.
Technical data and measurements for the JWBS-18 band saw.
Technical data and measurements for the JWBS-20 band saw.
Visual representation of base hole center dimensions for various models.
Steps for unpacking, checking contents, and preparing the machine for assembly.
Instructions for installing table, guide rail, and fence for proper alignment.
Procedures for installing the miter gauge and JWBS-20 table bracket.
Critical safety information regarding grounding and electrical circuit requirements.
Details on wiring configurations, circuit information, and extension cord usage.
Adjusting the resaw fence, fine adjustment, and table tilt for optimal performance.
Guide to changing blades and leveling the table insert for smooth operation.
Steps for setting proper blade tension and tracking for accurate cuts.
Adjusting upper blade guides and bearings for precise blade control.
Instructions for adjusting lower blade guides and thrust bearings.
Adjusting the guide post height and changing blade speed options.
Guidance on drive belt replacement, tensioning, and pulley alignment.
How to safely use the band saw's start and stop switch, including safety key.
Basic operating procedures, safety tips, and cutting techniques.
Methods for performing ripping, crosscutting, and resawing operations.
Guidelines for blade selection and common causes of blade breakage.
Routine maintenance tasks, lubrication points, and additional servicing recommendations.
Chart for selecting the appropriate blade based on material type and workpiece thickness.
Diagnosing and resolving common operational issues encountered with the band saw.
Troubleshooting guide for mechanical failures and electrical problems.
Information on contacting service and ordering replacement parts for the machine.
General
