How to fix inaccurate 45 or 90 degree cuts on a Jet JWBS-10OS Saw?
If your Jet Saw does not make accurate 45 or 90 degree cuts, the stop may not be adjusted correctly; check the blade with a square and adjust the stop. Also, the angle pointer may not be set accurately; check the blade with a square and adjust the pointer.
What to do if my Jet JWBS-10OS Saw stops or will not start?
If your Jet Saw stops or won't start, first check the plug connections to ensure the saw is properly plugged in. If the saw is plugged in, examine the fuse or circuit breaker; replace the fuse or reset the circuit breaker if needed. Finally, inspect the cord for any damage and replace it if necessary.
Why does the blade wander during cut with my Jet JWBS-10OS?
If the blade of your Jet Saw wanders during a cut, there are several potential causes. First, check and adjust the fence to ensure it is aligned with the blade. Second, consider if the wood is warped and select another piece if necessary. Third, reduce the feed rate if it's excessive. Fourth, change the blade to the correct type for the cut. Fifth, set the blade tension according to the blade size. Finally, review the guide bearing adjustment.
Details warranty terms, periods, and exclusions for JET products.
Explains the process for requesting service and repair for JET tools.
Essential safety guidelines for operating the band saw and avoiding injury.
Rules for safe machine operation, handling, and maintenance.
Instructions for assembling the legs and frame of the band saw stand.
How to properly tension the saw blade for optimal performance.
Ensuring the blade runs true and centered on the wheels.
Essential guidelines for safe electrical grounding of the band saw.
To Next Page
General
