VOLT™ V2 QUICK START GUIDE
21
SAFE USE GUIDELINES
WARNING
• Read and follow all instructions concerning the VOLT™ V2 setup, and installation of your bicycle onto the
VOLT™V2.
• Failure to securely attach the bicycle to the VOLT™ V2 could result in serious injury to the rider or bystanders.
• The Quick release skewer must be tightened rmly while bracing the bicycle with your other hand. A good
guide is when closed rmly, the lever will leave a clear imprint on the palm of your hand.
• Check your bicycle’s user manual to make sure use on bicycle trainers is not excluded.
• Always take care when training to prevent children or pets moving too close to the VOLT™ V2 Trainer.
• This VOLT™ V2 Trainer is intended for single-rider bicycles only.
• Before beginning each workout, you must check the bicycle is securely attached to the VOLT™ V2 Trainer.
• The VOLT™ V2 must always be used on a at surface.
• Do not use the VOLT™ V2 in wet conditions, this may harm the electronics.
• Do not put ngers, feet or dangling objects near any moving parts.
• Do not attempt to dismount until all moving parts have stopped.
• Do not attempt to modify your JetBlack VOLT™ V2 Trainer.
• Do not attempt to stop the resistance unit or ywheel manually.
• The resistance unit housing may become hot. Be careful not touch resistance unit housing until it has had
sufcient time to cool.
• Before you start any exercise program you should consult a physician. Should you become ill, feel dizzy,
light-headed or nauseous while riding the VOLT™ V2 Trainer, stop riding immediately and seek
medical attention.
• Check your bicycle’s user manual to make sure use on indoor trainers is not excluded.
Visit support.jetblackcycling.com
To Next Page
Loading...