JetCat P60 - Electrical Connection Pictures

74 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Electrical connection pictures

2x to receiver

(

THR/AUX

)

Fuel valve Propane valve

Propane valve

(below Air Speed input.)

Fuel valve to be

connected on

lower output

Page 22/74

Table of Contents

Default Chapter5
- Table of Contents5
Introduction8
Safety Precautions9
The Checklist10
- Before Running the Turbine10
- After Stopping the Turbine10
Fuel / Fuel Care11
- Fuel System11
- Hopper Tank12
- Prime the Pump and System12
- Fuel System Connection Diagram13
- Fuel Pump Adjustment14
- Starting Gas Diagram16
- Filling the Starting Gas Tank17
Mounting the Turbine18
- Suggested Turbine Installation18
Connections at the Turbine19
Electrical Connection Diagram (1/2)20
Electrical Connection Diagram (2/2)21
- Electrical Connection Pictures22
- Power Supply23
- Charging the Battery23
- Glow Plug23
Ground Support Unit (Gsu)24
- Gsu Control Panel Descriptions24
- Gsu Switch Descriptions25
- Gsu Led Descriptions25
The Led I/O Board26
Jetcat Ecu Version 4.0 - 5.0 Introduction27
Setting up the Ecu28
- Calibrate the Temperature Probe28
- Setup Failsafe Mode and "Learn Rc29
- Setting the Failsafe for Jr Pcm Receivers29
- Time in Failsafe (Seconds)30
- Number of Failsafes30
- Failsafe Delay31
- Failsafe Timeout31
- Failsafe Rpm31
How to Set Your Ecu for Single Channel Operation31
- Learn R/C". Teach the Ecu to the R/C System33
?Learn R/C”. TEACH the ECU to the R/C SYSTEM36
Test Functions36
Turbine Starting / Running36
- Manual Startup Without Using the Transmitter Directly from the Gsu37
Turbine Stopping / Cool down38
- Manual off38
- Auto off38
- Automatic Cooling Process38
Battery / Fuel Warning Function39
Turbine Running States39
- Explanation of the Turbine States39
- Explanation for Turbine Shut down42
Menu Structure43
- Menu Selections43
  - Selecting a Menu43
  - Change Values / Items43
- The Run Menu44
- The Min/Max Menu45
- The R/C Check Menu46
- The Info Menu46
- The Statistic-Menu47
- The Test Functions Menu48
- The Limits Menu48
  - Suggestions for Starting a Multi-Engine Plane Using Startup Mode53
Smoker Valve54
- Typical Smoke System Connections55
Troubleshooting56
- Reason for Shut-Down57
Maintenance59
- Reset the Ecu to the Factory Default Values60
Parts List62
- Optional Accessories62
Ducting63
- Connection Diagram for the Airspeed Sensor65
- Explanation of the Speed Regulator Options66
- Available Options67

Related product manuals

JetCat P300-PRO

JetCat P400-PRO

JetCat P550-PRO

JetCat P1000-PRO

Preview: JetCat SPH5

Preview: JetCat RX Series

JetCat RX Series

Preview: JetCat PRO Series

JetCat PRO Series