To Next PageTo Next Page
Need help?Do you have a question about the Jetfire J15 and is the answer not in the manual?
Specifies the type of heaters covered by the manual: industrial direct gas fired propane heaters.
Lists the specific JETFIRE models covered by this manual, including J8 through J90SA.
Identifies the manufacturer as Spitwater Australia Pty Ltd.
A prominent warning about following operating, safety, and maintenance instructions to avoid liability.
Detailed technical specifications for various JETFIRE models, including fuel, gas pressure, heat input, and dimensions.
Introduction to the JETFIRE range, emphasizing safe and efficient service and the manual's purpose.
Essential safety instructions and precautions for operating the heater safely and effectively.
Details the required electrical supply (220-240V Single Phase 50-60Hz) and earthing.
Recommendations for minimum gas cylinder sizes and quantities to prevent freezing.
Step-by-step instructions for installing the JETFIRE heaters, including connections.
Instructions for starting, using, and stopping manual control models of the JETFIRE heaters.
Instructions for starting, using, and stopping automatic control models of the JETFIRE heaters.
Procedure for using the heater as a summer ventilator without gas supply.
A guide to identifying common faults and their potential causes for automatic and manual models.
Detailed steps and checks for rectifying identified faults in the JETFIRE heaters.
General maintenance tasks including disconnecting power and gas, and removing covers.
Procedures for servicing and cleaning the burner, gas jet, and related components.
Checks for gas supply hose tightness, pipe connections, and leak detection.
Checks for motor fixing bolts, fan screws, limit thermostat continuity, and electrical connections.
General