JETI model Duplex REX7

Need help?

Do you have a question about the JETI model Duplex REX7 and is the answer not in the manual?

Summary

Introduction

Technical Data

Installation

Voltage Supply

Details on connecting power supply to Duplex receivers, including battery and BEC options.

Operation

Recommended procedure for switching the transmitter and receiver on and off.

Binding

Procedure for binding JETI Duplex receivers to transmitters using a bind plug or JETIBOX.

Real Time Telemetry

EX Telemetry

Details on EX telemetry data display using DC/DS transmitters and JETIBOX profi.

1 st Generation

Information on using 1st Generation Telemetry with TU, TG, TF transmitter modules.

Receiver Setup

Receiver setup via the JETIBOX

Instructions for configuring receivers using the JETIBOX, covering direct and wireless connection methods.

Receiver set-up via the DC;DS transmitter

Guide for setting up receivers directly using a DC/DS transmitter.

Receiver Menu

Overview of receiver data items

Details on the introductory display and specific data items like RX/TX and Rx Diag.

Measure

Functionality for reading measured data, including voltage, minimum, maximum, and actual values.

Main Setting

Configuration of Fail Safe, Signal Fault Delay, and Volt ACT/ALARM settings.

Out pin set

Setup of physical receiver outputs, including pin configuration for Servo, Digital, and Input modes.

Auto set

Loading default receiver configurations from preset modes and factory reset procedure.

Receiver Update

Examples of Rx Setup

Electrostatic Sensitive Device Handling Precautions

Information on Disposal