To Next PageTo Next Page
Need help?Do you have a question about the JETI model Duplex REX Assist Series and is the answer not in the manual?
Lists key features and capabilities of the REX A receivers.
Provides crucial warnings and recommendations for using the receiver.
Guidance on physically mounting the receiver within the model.
Details on how to power the receiver and connected components.
Steps for pairing the receiver with the transmitter.
Procedure to verify transmitter-receiver communication range.
Steps for quickly setting up the receiver for an airplane model.
How to fine-tune stabilization gains for individual axes in airplane models.
Initial setup steps for configuring the receiver with a multicopter model.
Steps for optimizing multicopter stabilization settings and motor behavior.
Description of the basic airplane mode with stabilization deactivated.
Basic functions to stabilize multicopter in horizontal position.
Allows basic aerobatics by stabilizing rotation speeds in individual axes.
Feature to suppress oscillations in multicopters when throttle changes rapidly.
Suppresses oscillations in stabilized flight at high speeds for airplanes.
Setting individual PID control coefficients for stabilization.
Adjusting parameters for the "Stabilize" mode, like tilt angles.
Configuring the fail-safe function and its behavior during signal loss.
Troubleshooting common issues related to transmitter configuration and files.
Solutions for oscillations and direction holding problems in airplane models.
Troubleshooting issues with motors not spinning and multicopter oscillations.
Instructions for updating the receiver firmware using a PC and USB adapter.
Configuring receiver settings using the JETI Studio software.
Lists key features and capabilities of the REX A receivers.
Provides crucial warnings and recommendations for using the receiver.
Guidance on physically mounting the receiver within the model.
Details on how to power the receiver and connected components.
Steps for pairing the receiver with the transmitter.
Procedure to verify transmitter-receiver communication range.
Steps for quickly setting up the receiver for an airplane model.
How to fine-tune stabilization gains for individual axes in airplane models.
Initial setup steps for configuring the receiver with a multicopter model.
Steps for optimizing multicopter stabilization settings and motor behavior.
Description of the basic airplane mode with stabilization deactivated.
Basic functions to stabilize multicopter in horizontal position.
Allows basic aerobatics by stabilizing rotation speeds in individual axes.
Feature to suppress oscillations in multicopters when throttle changes rapidly.
Suppresses oscillations in stabilized flight at high speeds for airplanes.
Setting individual PID control coefficients for stabilization.
Adjusting parameters for the "Stabilize" mode, like tilt angles.
Configuring the fail-safe function and its behavior during signal loss.
Troubleshooting common issues related to transmitter configuration and files.
Solutions for oscillations and direction holding problems in airplane models.
Troubleshooting issues with motors not spinning and multicopter oscillations.
Instructions for updating the receiver firmware using a PC and USB adapter.
Configuring receiver settings using the JETI Studio software.
General| Frequency | 2.4 GHz |
|---|---|
| Telemetry | Yes |
| Duplex 2.4GHz | Yes |
| Type | Receiver |
| Operating Voltage | 4.0 - 8.4 V |
| Stabilization | Yes |
| Voltage Range | 4.0 - 8.4 V |
| Antenna | 2 |
| Protocol | Duplex EX |
