JETI model Duplex REX7 - Page 19

computer radio control system
Output Trim - neutral throw setup for receiver output
Gain A - amplification of the output throw in the negative half-plain
A (from -150 to 0%)
Gain B - amplification of the output throw in the positive half-plain
B (from 0% to 150%)
Signal Fault - setup of the receiver behaviour in case of signal loss,
„hold“- holds the most recent control throw, „out off“ – output
switch-off (no signal generated), „failSafe“ – moves to preset throws
for the individual outputs
FS position - FailSafe output position in case of signal loss
FS speed - sets how quickly the throws move to the FailSafe
positions in case of signal loss
Output Group - setup of given output into a selected group of
output pulses, which will be simultaneously generated by the
receiver.
EN
17
®
User ManualUser ManualUser Manual
EN
Receivers REXReceivers REX
FW 1.00FW 1.00
Receivers REX
FW 1.00
COMPLEX RADIO CONTROL SYSTEM