Jetson Arro - Securing the Bell

26
1.4 Securing the Bell
1. LOOSEN BUT DO NOT REMOVE THE SCREW ON THE BELL CLAMP BY TURNING IT COUNTERCLOCKWISE FOR
1  2 ROTATIONS WITH THE SCREWDRIVER TIP OF THE 2BIT TOOL.
2. ROTATE THE BELL AROUND THE HANDLEBAR UNTIL THE BELL TAB IS IN A PLACE THAT CAN EASILY BE REACHED BY
THE RIDER'S LEFTHAND THUMB WHILE HOLDING ONTO THE HANDLEBAR.
3. WHILE HOLDING THE BELL IN THAT POSITION, TIGHTEN THE CLAMP BY TURNING THE SCREW CLOCKWISE WITH
THE SCREWDRIVER TIP OF THE 2BIT TOOL.
BELLBELL TAB
SCREW
2BIT TOOL