1.3 Attaching the Seat
1. PULL OPEN THE LATCH ON THE SEAT CLAMP.
2. LOCATE THE "MINIMUM INSERTION" MARK ENGRAVED
NEAR THE BOTTOM OF THE SEAT POST.
3. HOLD THE SEAT IN POSITION ABOVE THE BIKE, WITH
THE WIDEST PART OF THE SEAT AT THE REAR.
4. LOWER THE SEAT POST DOWN THROUGH THE CLAMP AND
INTO THE SEAT TUBE UNTIL THE MINIMUM INSERTION
MARK IS BELOW THE CLAMP.
TROUBLESHOOTING: IF THE CLAMP OPENING IS TOO
NARROW TO RECEIVE THE POST, YOU CAN WIDEN IT BY
TURNING THE KNOB ON THE CLAMP COUNTERCLOCKWISE
WHILE HOLDING THE LATCH STEADY.
SEAT POST
MINIMUM INSERTION MARK
CLAMP LATCH
SEAT
SEAT CLAMP
CLAMP KNOB
To Next Page
Loading...
Need help?
General
