1. Using the 6mm Allen wrench from your
tool kit, remove the four bolts and two
handlebar clamps from the top of the fork
and set aside.
2. Place the handlebars into position in the
lower clamps. Take care to get the
handlebars centered side to side, and set
in your desired upright position.
Be careful not to lean the handlebars too far forward or
3. Place the top clamps and bolts in position and tighten the four bolts
securely to 12 ft. lbs.
DO NOT OVERTIGHTEN.
STEP 1.
UNPACK YOUR Jetson jr.. The contents is as follows:
1. Jetson jr. Electric Minibike
2. Tool Pouch with tools
3. Battery Charger
4. Owners Manual
Once you have located all of these items, move on to step 2.
INITIAL SET-UP
STEP 2. ATTACH THE HANDLEBARS Your Jetson jr. arrives almost
completely assembled, making it easy to start riding. The only assembly that is required
for your Jetson jr. is to attach the adjustable handlebars. All cables and controls are
already hooked up to the bike, so attaching the handlebars is easy:
backward as this will affect the bike's handling and comfort of the ride.
STEP 3. CHARGE THE BATTERY First, be sure that the toggle switch on the
top of the "tank" in switched to the off position.
Locate the battery charger port which is under the seat on the right side
(shown at right) and flip up the small round black protective cap. Underthis cap you
will see a round connector with three small contact posts. Note that there is a small
spline at the bottom of the connector.
On the round end of the battery charger cord, you will see a plug that has three small
holes and a notch which fits into the conector on the minibike. Insert the plug into the
connector firmly. There is a round ring-nut that you can use to tighten the plug into the
connector, but this is optional.
www.jetsonbike.com 6
To Next Page
Loading...
Need help?
General
