www.jetsonbike.com 17
1. Open the plastic battery case by removing both knob screws
(on the front and back of the battery case) and pulling the right
side panel off.
2. Locate the black rubber fuse housing, in the wiring above the
battery.
3. Open the rubber flip top lid and carefully pull out the fuse.
4. Inspect the fuse and replace if necessary.
5. Re-assemble the fuse holder and the body case, making sure
it is clean and dry inside and that all the wiring is safely tucked
inside. Watch carefully for pinched wires.
NOTE: IF THE FUSE CONTINUES TO BURN OUT YOU
HAVE ENCOUNTERED AN ELECTRICAL PROBLEM.
STOP USING THE BIKE AND CALL JETSON AT (888)
976-9904 OR EMAIL US AT
CUSTOMERSERVICE@JETSONBIKE.COM FOR ASSIS-
TANCE.
The Jetson jr. is equipped with a mechanical rear disc brake system. You should check
the brake and make sure it is working properly before each ride. The brake should feel
firm when the lever is pulled and you should not be able to pull the brake lever all the
way back to where it touches the hand grip. If you can squeeze the brake lever all the
way to the hand grip, your brake needs adjusting.
There are two options to adjust the brakes:
OPTION 1: Adjust using the barrel roller.
1. Loosen the set ring on the barrel adjuster.
2. Screw the barrel adjuster out a few turns and then
check the tension in the lever.
3. If it feels right, re-tighten the set ring.
4. If not, repeat step 2 until the brake feels right and
then tighten the set ring nut.
REPLACING THE FUSE (CONTINUED)
ADJUSTING THE BRAKE
MAINTAINING YOUR JETSON JR.
To Next Page
Loading...
Need help?
General
