Jetson X10 - Get Started; Charging the Battery; Indicator Lights; How to Recalibrate

*Adults must assist children in the initial adjustment procedures of the product.
1. Get Started
1.1 Charging the Battery
1.2 Indicator Lights
1.3 How to Recalibrate
• Only use the included charger
• Plug the charger into the wall before the Charging Port
• Don’t turn on the X10 while it’s charging
• Charge the battery until it is fully charged before use - up to 3 hours
- Charging
- Charge Complete
Light
> 20% 20-30% 30% +Percentage
Warning: The X10 will automatically turn off once the battery power
goes below 10% as a safety precaution.
Status Light: If this light turns red or if you are having issues with
the X10, you may need to recalibrate it.
Balance Light: Active Balance Technology is on, which levels the X10
as you ride.
Power Light: the X10 is powered on.
Follow these 3 simple steps...
1. Place the X10 on a flat, level surface.
2. Hold the Power Button (for about 5 seconds) until you are notified
of a successful recalibration.
3. Restart the X10 by turning it off and then on.
Hold for 5 seconds
Indicator Light
Status
Light
Power
Light
Balance
Light