Jetwave Scorpion G2 - Operating Instructions

11
SCORPION G2 MANUAL - WATER JETTER/DRAIN CLEANER
Operating Instructions
CAUTION
Always wear eye protection to protect your eyes
against dirt and other foreign objects. Always wear
appropriate personal protective equipment for the
work environment.
Never operate the jetter with the hose end out side
of the drain. Hose can whip, causing striking injuries
and spray can penetrate skin and cause serious
injury.
High pressure uid can inject under skin resulting
in serious injury, including amputation. do not
direct spray at people or animals. do not operate
jetter above pressure rating or 60°C (inlet water
temperature). This increases the risk of injury,
including burns, and damage to the jetter. one person
must control the jetting process and water ow. If the
jetter hose comes out of the drain, the operator must
be able to shut off the water ow to reduce the risk
of the jetter hose whipping, causing striking and high
pressure injection injuries.
Always use appropriate personal protective
equipment while handling and using drain cleaning
equipment. drain may contain chemicals, bacteria
and other substances that may be toxic, infectious,
cause burns or other issues. Appropriate personal
protective equipment always includes safety glasses
and gloves, and may also include equipment such
as latex or rubber gloves, face shields, goggles,
protective clothing, respirators, and steel toed
footwear.
Follow operating instructions to reduce the risk of
injury from whipping hoses, high pressure liquid
injection, carbon monoxide and other causes.
1. Make sure that machine and work area is properly set
up and that the work area is free of bystanders and
other distractions. If the jetter is located remotely from
the point of use, another person should be located at
the jetter.
2. Insert the hose with nozzle attached into the drain at
least 1m (3ft) so that the end of the hose will not come
out of the drain and whip around when the machine is
started.
3. Turn the battery isolator switch ON and conrm the
Emergency stop button is in the out position (rotate
button clockwise) (Figure 11).
4. Conrm that the water supply is turned on and the
water tank is full. Never start the engine without the
water supply turned ON. This can damage the pump.
5. Grip the hose near the pipe opening. Open the
selected water control valve (ball or foot valve). Start
the engine with key. Set the throttle to the full open
position. Conrm that water ows freely through the
nozzle. Close water control valve. When the water
control valve is closed and the jetter is running, the
unloader valve will recirculate water back to the tank.
Allow the engine to warm up.
PUMP OIL SIGHT GLASS
GEARBOX OIL SIGHT GLASS
Figure.11