SCORPION G2 MANUAL - WATER JETTER/DRAIN CLEANER
6
The machine serial number is located on the frame.
The last 4 digits indicate the month and year of the
manufacture. (01 = month, 18 = year).
NOTICE This machine is made to clean drains. If properly
used it should not damage a drain that is in good condition
and properly designed, constructed and maintained.
If the drain is in poor condition or not properly designed,
constructed or maintained, the drain cleaning process
may not be effective or could cause damage to the drain.
The best way to determine the condition of a drain before
cleaning is through visual inspection with a camera.
Improper use of this jetting machine can damage the jetter
and the drain. This machine may not clear all blockages.
Machine Assembly
WARNING
To prevent serious injury during use and prevent
machine damage, follow these procedures for proper
assembly.
Engine Oil
NOTICE The jetter is shipped with oil in the engine.
Operating the engine with low or no oil will result in engine
failure. See supplied engine operator’s manual for specic
information on checking oil, adding oil and oil selection.
Pump/Gearbox Oil
The jetter is shipped with oil in the pump and gearbox.
Check oil level (ensure half way on sight-glasses) per
Maintenance section.
Pre-Operation Inspection
WARNING
Before each use, inspect your water jetter and
correct any problems to reduce the risk of serious
injury from high pressure water and other causes and
prevent jetter damage.
Always wear safety glasses, gloves and other
appropriate protective equipment when inspecting
your jetter to protect against chemicals and bacteria
on the equipment
1. Make sure that the battery isolator and engine switch is
in the OFF position.
2. Clean any oil, grease or dirt from the equipment,
including the handles and controls. This aids inspection
and helps prevent the machine or control from slipping
from your grip.
3. Inspect the water jetter and accessories for the
following:
• Proper assembly and completeness.
• Broken, worn, missing, misaligned, binding or loose
parts.
• Presence and readability of the warning labels.
(See Figure 4.)
• Any other condition which may prevent the safe
and normal operation.
If any problems are found, do not use the water jetter until
the problems are corrected.
Figure.4A - Scorpion G2 Warning Labels
Figure.4B - Scorpion G2 Warning Labels
Clean water lter (Figure 5). Using the drain valve, drain
the tank. Unscrew the brass cover from bottom of the lter
and remove and clean the mesh lter. Dirt and debris can
restrict the water ow to the pump and cause performance
issues.
To Next Page
Loading...