EasyManua.ls Logo

JGaurora A3S - Filament Handling; Loading Filament into Extruder

JGaurora A3S
34 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Tap“HEAT”-“Preheat”-“Extruder 1 (E1)”
Hit“ADD”
to heatup Extruder 1 to 200℃
Note: Only PLA is used here as filament for demonstration.
Operation
Loading Filament
17

Table of Contents

Related product manuals