A SUCCESSFUL FIRST LAYER is VITAL to a successful print.
After the printer is assembled and leveled, we suggest you WATCH CAREFULLY when you're printing
the first layer.
If not, you can try tightening or loosening the spring bolts below the hot bed while printing to adjust the distance and re-level the bed.
If the printer is perfectly leveled, you should get nice, flat lines of filament with no gaps between that strongly adheres to the bed.
Operation
Bed Leveling
Note: You're highly recommended to watch video tutorials first or contact JGAURORA before leveling or if you have any problems in leveling.
16
To Next Page
Loading...
