22
Reload the supplemental filament as follows if filament is about to run out during printing:
Tap“OPTION”in printing interface and choose“PAUSE”, the X axis goes back to home point.
Hit“MORE”- “CHANGE”, select“OUT”to eject the remaining filament.
Put on a new spool of filament and hit“IN”to feed till the filament comes out of the nozzle.
Tap“BACK”twice to enter printing mode, hit“RESUME”to resume printing.
Operation
Replacing Filament
Note: 1. Remember to preheat the nozzle first to required temperature if replacing filament after printing completes.
2. Always pull out the remaining filament gently and carefully so as not to damage the nozzle/extruder.
To Next Page
Loading...
