JLAB.COM
CAUTIONS
• Avoid extreme heat, cold, and humidity.
• Avoid dropping or crushing the earbuds.
• Wax may build up in the earbud tips, lowering the sound quality.
Carefully remove the wax with a cotton swab or other small tool to improve the sound quality.
• If you experience discomfort or pain, try lowering the volume or discontinuing use temporarily.
• If you experience regular discomfort while using this product, discontinue use and consult your physician.
• We recommend you treat your earbuds as you would a nice pair of sunglasses and keep them in safe location when not in use.
Shop products | Product alerts | Burn-in your headphones
JLab Store + Burn-in Tool
• The left or right earbud can be used independently for music and phone
calls. Simply choose one and take out of the case to connect.
• Choosing the correct ear tip makes a significant improvement in audio
quality due to the proper seal for the driver. Test all ear tips for best
results.
• Only ONE Bluetooth device can be connected at a time. Turn off
Bluetooth on unwanted devices and turn on Bluetooth on chosen
device to connect.
QUICK TIPS WARNING
Fully dry off the earbuds before
placing in the charging case.
If the earbuds are damp or wet,
this will cause damage to the
charging case. The warranty will
be voided if the charging case
shows damage by water/sweat.
TROUBLESHOOTING
NO AUDIO IN LEFT EARBUD OR EARBUDS DISCONNECT FROM EACH OTHER
(MANUAL RESET)
BLUETOOTH DEVICE DOES NOT CONNECT/RECONNECT
Enter your Bluetooth device settings and forget the JBuds Air Sport. Fig
1
Turn OFF then ON Bluetooth. Fig
2
1
2
Take the earbuds out of the case. Wait for one to turn solid white and the
other to blink blue/white.
Select “JLab JBuds Air Sport” in device settings to reconnect.
3
4
Enter your Bluetooth device settings and forget the JBuds Air Sport. Fig
Open the charging case door and leave both earbuds inside. Starting with ONE earbud,
quickly tap the touch sensor 7x times. Light will blink blue 4x times.
Leave the earbuds in the charging case. Fig
Repeat with the other earbud. Quickly tap the touch sensor 7x times.
Light will blink blue 4x times. Fig
3
Take both earbuds out of the charging case and keep them within 2 inches from each other.
Wait for one earbud to turn solid white and the other to blink blue/white.
You are now ready to pair to your Bluetooth device.
4
A
A
B
Instructional videos at: JLAB.COM/MANUALS
C1
Bluetooth
Settings
A
Bluetooth
Settings
JLab JBuds Air Sport
i
B
C
C1
C2
C2
To Previous Page
Loading...
Need help?
General
