1.- PRESENTATION AND GENERAL ASPECTS
1.1 GENERAL POINTS
1.2 TRANSPORT AND PACKING
1.3 IDENTIFICATION LABEL
2.- CHARACTERISTICS OF THE MACHINE
2.1 PARTS OF THE KEY
2.2 MAIN ELEMENTS OF THE MACHINE
2.3 TECHNICAL INFORMATION
2.4 COMPONENTS AND FUNCTIONAL PARTS
2.4.1 ACCESSORIES
2.4.2 ELECTRIC CIRCUIT
2.4.3 FOUR-SIDED CLAMP
3.- HOW TO OPERATE THE MACHINE
3.1 DISPLAY FUNCTIONS
3.2 CHANGING THE SIDE ON THE CLAMP
3.3 ADJUSTMENT BY ELECTRICAL CONTACT
3.3.1 DEPTH ADJUSTMENT
3.3.2 SIDE ADJUSTMENT
3.4 CONVENTIONAL ADJUSTMENT (WITH NO ELECTRICAL CONTACT)
3.4.1 DEPTH ADJUSTMENT (WITH NO ELECTRICAL CONTACT)
3.4.2 SIDE ADJUSTMENT (WITH NO ELECTRICAL CONTACT)
3.5 KEY CUTTING
3.5.1 CUTTING KEYS WITH A NARROW BLADE
3.5.2 CUTTING KEYS WITHOUT SHOULDERS
3.5.3 CUTTING CROSS-SHAPED KEYS
4.- MAINTENANCE
4.1 REPLACING THE BRUSH
4.2 REPLACING THE CUTTER
4.3 REPLACING THE TRACER
4.4 ADJUSTING THE MAXIMUM DEPTH OF THE SLIDE
4.5 REPLACING THE FUSES
4.6 REPLACING THE START SWITCH AND THE BRUSH BUTTON
4.7 REPLACING AND/OR TIGHTENING THE BELT
4.8 REPLACING THE MOTOR
4.9 REPLACING THE MOTOR CAPACITOR
4.10 REPLACING THE CLAMP RAISING CAM
4.11 ACCESS TO THE INSIDE OF THE SLIDE
4.12 TIGHTENING THE SLIDE SPRING
4.13 ACCESS TO THE BOTTOM AREA
4.14 REPLACING THE MICROSWITCHES
4.15 REPLACING THE DISPLAY
4.16 REPLACING THE ELECTRONIC CARD
5.- SAFETY
6.- WASTE DISPOSAL
6.1 PACKING
6.2 SWARF
6.3 MACHINE
7.- EXPLODED VIEW
To Next Page
Loading...
