JMPosner SQ1 - Assembly Instructions by Model; SQ1 Assembly Steps

6
FOUNTAIN ASSEMBLY SQ1
Fig. 1
Fig. 2
Fig. 3
Fig. 4
»
STEP 1
Removefountaincomponentsfromtheirboxes
andplacefountaindrumonasturdy,level
surface.Makesurethedrumislevelsothatthe
chocolatewillowproperly(Fig.1).
STEP 2
Placeaugerontopofthesquarecentershaftin
themiddleofbasin(Fig.2).
STEP 3
Placethecentercolumnontothecentre
housinginthemiddleofthefountainbase(Fig.
3).Ensurethattheslotonthecolumnbaselines
upwiththelocatingpinontheinsideofthe
housing.
STEP 4
PlacetheTiersonthecentercolumn.Largeone
rstandthesmalldishlast(Fig.4).
STEP 5
Placethetophatontopofthecentercolumn
makingsurethattheaugerpinsitsinthemiddle
ofthetophatring.
Centre & Locating Pins
Slot in column