Joape Bob - Installation

WARNING
5
If the electrical cord for power supply gets damaged, it can ONLY be replaced by
the manufacturer or authorized agent.
For maintenance, contact customer service at: admin@southbee.com or
www.southbee.com
IMPORTANT WARNINGS
• The centrifugal disk spins at 3,500 RPM, do not place your hand or any other
object on it when the fan is operating.
• Be careful not to spill water on the electrical part of equipment.
• NEVER turn you equipment ON without water in the reservoir.
• Do not add untreated water to the water reservoir.
• Do not clean Joape BOB with harsh chemicals or abrasive products.
• ALWAYS remove the water from the reservoir to store your Joape BOB.
• Cleaning is essential for a proper performance of the equipment.
1 - Remove the equipment from the packaging. Make sure no packing materials are
in the fan area.
2 - Place the equipment on a flat and clean surface at least 32" off the ground.
3 - Add up to two gallons of water to the reservoir (picture 1).
4 - Connect the plug into a 110V electrical outlet.
5 - Turn the On/Off knob to the ON position. (picture 2).
6 - Use the mist adjustment knob to regulate the mist flow according to the
environment needs. (picture 3)
Note: When used indoors, the mist adjustment should be set on a very fine mist.
Installation
2
3
Maximum level
dimerdimer
1