Joape Bob User Manual

6
4
5
A
C
B
In areas with hard water, it may be necessary to occasionally clean the pump. Also in
areas with hardwater, at the end of the season or if not used for long periods, follow
this recommended cleaning procedure:
1 - Disconnect the equipment from the electrical outlet
2 - Use liquid detergent and a brush to clean the equipment.
3 - When the equipment is not used for more than 7 days,
the reservoir must be emptied, and cleaned, then run all water through once.
4 - In areas with hard water, it may be necessary to occasionally clean the
submersible water pump inside the reservoir.
Cleaning Instructions
1 - Remove the pump from the water reservoir (picture 4).
2 - Remove the frontal cover of the water inlet (picture 5/item "A").
3 - Remove the protective cover from the rotor (picture 5/item "B").
4 - Remove the propeller from the engine (picture 5/item "C").
5 - Clean all pump parts with water and neutral liquid soap.
6 - Rinse all parts and reassemble the pump.
Cleaning the Water Pump

Joape Bob Specifications

General

Brand	Joape
Model	Bob
Category	Fan
Language	English