VC2 14
TECHNICAL SPECIFICATION.
MICROPHONE INPUT.
• XLR Input 3Kohm and 800 ohm (switchable to suit 200 ohm and 50 ohm microphones).
• Transformer balanced and floating. Switchable 48V phantom power.
• Input level from -80dB to 0dB (20dB pad switch)
• Push button 200/50 ohm source switch (on rear panel).
• Push button MIC/LINE switch.
• Push button 20dB pad switch.
• Push button 48V phantom supply switch with LED indicator.
LINE INPUTS.
• XLR 10K impedance floating balanced.
• Mix input unbalanced 10K impedance.
OVERLOAD MARGIN.
• 30dB on Mic and Line inputs in normal operation.
GAIN.
• Line in -6dB to 24dB
• Mic in 15dBto 68dB
• Insert gain 0dB
• Mix in gain 0dB
NOISE.
• Line in 80dB below operating level
• Mic in 125.5dB below input at 50dB gain 20Hz to 20KHz.
HARMONIC DISTORTION.
• Generally within 0.05% rising to approx. 0.14% at 4dB above nominal output level. 2nd harmonic
predominant.
AMPLITUDE FREQUENCY RESPONSE
• Line in 10Hz to 15KHz within 0.5dB
• Mic in 10Hz to 15KHz within 1dB
• High pass filter 3dB down at 25Hz, 12dB per octave.
PHASE REVERSE.
• Push button phase reverse switch and LED indicator; reverses phase of all signals.
FILTER.
• Push button high pass filter switch (andindicator) operates at 25Hz at 12dB per octave.
To Next Page
