2.1.2 Installation music desk
1. Turn countersunk brass screws (A) into music desk slat (B) by hand till screws
stick out 2 mm (C).
2. Place music desk at the right position, with screw points into the pre-drilled
holes (D).
3. Tight music desk with screw driver. Electric screw driver is not
recommended.
4. Remove green protection foils (E) from plexiglas part of the music desk.
2.1.3 Installation pedal board
1. Shift pedal board against black
pedal front cover (A). Pedal bolts
(B) will stick out 5 mm.
2. For security reasons mount
pedal board to organ with wing
nuts (C).
To Next Page