Johnson Controls HVAHP036B21S - Page 77

OPTIONAL PARTS
TC-16001-rev.5
3-11
(2) Toppling Prevention Tool (for Snow Protection Hood attached): ASG-SW20A
The Toppling Prevention Toll should be utilized to prevent the outdoor unit from overturning.
(It is not possible to use the toppling prevention tool along with the Wind Prevention Tool.).
No. Accessory Qty.
1
Eyebolt (SUS, M6)
(with Square Washer, Spring Washer and Nut)
4 sets for each
2
Securing Plate
(SUS)
4
3
Wire (SUS)
f1/16 inch (2mm) x 66 ft (20m)
1
4
Fastening Fitting 8
37-13/16
(960)
36-13/16
(935)
* The estimated dimensions of installation with a wire angle of 60
o
.
46-3/4
(1187)
Toppling Prevention Tool
Snow Protection Hood
(for Rear Side)
Snow Protection Hood
(for Front Side)
47-1/4
(1200)
Toppling Prevention Tool
inch (mm)
(60
o
) (60
o
)
Hole for M8
Hole for M6

< Installation Position >