Installing the NAE/NIE Technical Bulletin2
Installing the NAE/NIE
Introduction
The Network Automation Engine (NAE)/Network Integration Engine
(NIE) monitors and supervises networks of devices that typically
control Heating, Ventilating, and Air Conditioning (HVAC)
equipment, lighting, security, and building access. The NAE/NIE unit
is delivered with the operating system software already installed, but
the user needs to provide site-specific data. Through a standard Web
browser interface, the NAE/NIE provides features including alarm and
event management, trending, archiving, energy management, data
exchange, scheduling, dial features, and password protection.
This technical bulletin describes the hardware features of the
NAE/NIE and how to:
• mount the NAE/NIE
• install the data protection battery
• wire the NAE/NIE
• turn off the NAE/NIE
Notes: Unless otherwise noted, the information in this document
applies to the NAE and the NIE.
(For the United States of America only.) This equipment has been
tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the United States Federal Communication
Commission (FCC) rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy, and if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case
the user must correct the interference at his own expense.
For other countries and regions, refer to Agency Listings in
Specifications in this document.
To Next Page
Loading...
Need help?
General
