UNDERWRITERS LABORATORIES COMPLIANCE VERIFICATION SHEET
The following model numbers are listed under Underwriters Labo
ratories UL 1076 for Proprietary Burglar
Alarm Units and Systems and UL 294 for Access Control Systems Units.
S300-DIN-RDR2S
When installed at the site the following requirements must
be met to comply with these standards.
1. The S300-DIN-RDR2S shall be mounted in subassembly
S300-DIN-L or S300-DIN-S.
2. The S300-DIN-RDR2S in combination with the S300-DIN-L or
S300-DIN-S must be connected to a UL
Listed Uninterruptible Power Supply that provides a minimum of 24 hours of AC emergency power.
3. The tamper switch must be enabled at all times.
4. Transient protection devices that are installed
must not be removed or defeated.
5. Do not connect equipment to an AC power s
ource that is controlled by a switch.
To Next Page
Loading...
Need help?
General
