Johnson Controls TEC3011 User Manual

TEC3000 Series Wireless Proportional Fan Coil and Individual Zone Thermostat Controllers with Dehumidification
Capability Installation Instructions
24
Configuring Occupancy
To adapt to nearly any application, the TEC3000 controller supports a wide variety of occupancy sources, such as:
• Local stand-alone weekly scheduler
• External schedule from the BAS
• Occupancy sensor (internal or remote)
• Occupancy binary input (configurable)
• Manual occupancy override
• Temporary occupancy (by interacting with the screen while unoccupied)
• Temporary occupancy binary input
Occupancy is determined using a top-down decision matrix as shown in Table 7.
Occ Setpoint Select =
Setpoint Offset and
Heat Cool Setpoint Mode =
Common Setpoint
In this mode, the TEC has one setpoint, Common Setpoint, for heating and cooling. There is
also a common Setpoint Offset (warmer/cooler adjust) that is only applied to Common
Setpoint. Otherwise, this setting works the same as when Occ Setpoint Select = Setpoint
Offset and Heat Cool Setpoint Mode = Individual Setpoints.
Occ Setpoint Select = Min
and Max Setpoints and
Heat Cool Setpoint Mode =
Common Setpoint
In this mode, the TEC has one setpoint, Common Setpoint, for heating and cooling. There is
a configurable range for Common Setpoint, Min Setpoint, and Max Setpoint.
Table 6: Setpoint Operation
Mode of Setpoint
Operation
Details

Johnson Controls TEC3011 Specifications

General

Brand	Johnson Controls
Model	TEC3011
Category	Controller
Language	English