To Next PageTo Next Page
Need help?Do you have a question about the Johnson Controls YC2D Series and is the answer not in the manual?
General| Brand | Johnson Controls |
|---|---|
| Model | YC2D Series |
| Category | Air Conditioner |
| Language | English |
Information about product certifications and standards compliance.
Safety alerts and signal words (Danger, Warning, Caution) to prevent injury.
Procedure for inspecting the unit for transit damage upon receipt.
Specific requirements for R-410A systems, including equipment rating.
Constraints and limitations for installing and operating the unit.
Guidance on selecting a suitable location for the outdoor and indoor units.
Steps for installing the filter-drier on the outdoor unit.
Steps for installing the filter-drier on the indoor coil.
Guidelines for safe and effective installation of refrigerant lines.
Safety and technical precautions for brazing refrigerant lines.
Specific precautions for brazing around service valves.
Step-by-step procedure for connecting refrigerant lines.
Basic steps for installing a TXV kit.
Steps to evacuate the system to 500 microns or less.
Method for determining and adjusting indoor airflow for system efficiency.
Procedures for determining and adding the correct refrigerant charge.
Steps for charging a TXV indoor system using subcooling method.
Table of saturation properties for R-410A refrigerant.
General electrical safety, grounding, and wiring practices.
Instructions for connecting the main power wiring to the unit.
Instructions for connecting the low-voltage control wiring.
General field wiring practices and diagram references.
Guidance on system operation, features, and warranty for the end-user.
Recommended maintenance tasks for ensuring unit longevity and performance.
Electrical schematic for single-phase units with 13.4 and 14.3 SEER2 ratings.
Electrical schematic for single-phase units with 15.2 SEER2 single-stage rating.
Electrical schematic for single-phase units with 15.2 SEER2 two-stage rating.
Electrical schematic for three-phase units with 13.4 SEER2 rating.
Checklist and form for initial system start-up and verification.
Settings for airflow and blower operation as part of start-up.
Details for setting refrigerant charge and metering device during start-up.
Performing unit cycle tests and final site cleanup post-installation.
Guidance for educating the owner on system use and maintenance during start-up.
