Need help?Do you have a question about the Johnson Hardware 1700 and is the answer not in the manual?
General| Brand | Johnson Hardware |
|---|---|
| Model | 1700 |
| Category | Door |
| Language | English |
Ensure opening corners are square, header is level, and jambs are straight for proper installation.
Install the track 3/4" (19mm) from the front edge of the head jamb.
Attach hinges (1703) to the back of the door panels, laying them face down.
Secure pivot plates to the top and bottom of the doors as illustrated.
Mark the jamb bracket (1711) location on the jamb and fasten it.
Insert pivots into track, secure them, and adjust if necessary for proper door hanging.
Install the knob (33) and the aligner (1808) on the back of lead doors.
Adjust the snubber (1713) so doors snap shut easily but open smoothly.
To Next Page