901-10113 - 18 - 9/16/2024
3.6 Returning From Route Instructions
The refrigerated compartment must be re-cooled to prepare it for the next route. Follow these steps:
Clean frost from plates daily with Defrost
Brush (if equipped). Avoid hitting
refrigerant piping and valves.
Ice scraping tools are NOT
RECOMMENDED.
Defrost brush pictured at right.
Defrost Needed. See Section 3.7.
Retrieve Cord.
Typically stored in cab or cord box.
Plug male cord end into matching AC
electrical outlet.
Building receptacle’s disconnect switch
may be turned on; cord may be
energized when plugging in to truck.
Plug female cord end into electrical inlet
on truck.
Ignore this step if cord box is hard-wired.
To Next Page
Loading...