Maintenance - 45
FUSES
IMPORTANT: Always carry spare fuses. Use the
spare fuse holder to hold an extra fuse.
The fuse is located in the fuse holder. Refer to En-
gine Specifications.
1. Fuse holder
1. Spare fuse holder
Fuse Failure
A minor electrical problem can blow a fuse. Re-
place it with a fuse of the same rating.
Repeated failures of fuses in the same position in-
dicate a serious problem. Do not replace it with
higher rated fuses; see your Dealer for service.
SPARK PLUGS
Inspect spark plugs periodically. Replace if elec-
trodes are badly worn, insulators are cracked, or if
they are badly fouled.
To remove spark plugs, twist and remove all spark
plug leads. Unscrew spark plug from cylinder head.
To install spark plugs, wipe spark plug seats clean
with a clean rag. Install spark plugs finger tight, then
tighten to specified torque. Refer to Engine Speci-
fications.
IMPORTANT: Avoid engine damage by installing
spark plugs into COOL cylinder head and not over-
tightening.
Before installing the spark plug lead, apply a light
coat of
Triple-Guard
grease to the ribbed portion of
the spark plug. This will help prevent corrosion be-
tween the spring terminal and the spark plug.
1. Ribbed portion of the spark plug
Fuse Color Circuit P/N
15-Amp Blue Fuel Pump 505723
30-Amp Green
EMM
, Trim/Tilt Switch,
Rectifier/Regulator
505726
1
1
WARNING
The ignition system presents a serious
shock hazard. The primary circuit operates
in excess of 250 volts; the secondary circuit
operates in excess of 25,000 volts. Use cau-
tion to avoid injury from shock or injury
resulting from your reaction to shock. Do
not handle primary or secondary ignition
components while the engine is cranking or
running.
1
To Next Page
Loading...
Need help?
General
