17
18
Use Rain Cover
To assemble the rain cover A
23
, place it over the stroller, and then attach the 4 pairs of hook and loop
fasteners on the rain cover.
24
To assemble the rain cover B
25
, place it over the stroller, and then attach the 10 pairs of hook and loop
fasteners on the rain cover.
26
! Before using the rain cover, please make sure the backrest has been adjusted to the lowest position and the
infant child restraint has been fastened.
26
! When using the rain cover, please always check its ventilation.
! When not in use, please check the rain cover has been cleaned and dried before folding.
! Do not fold the stroller after assembling the rain cover.
! Do not place your child into the stroller assembled with rain cover during hot weather.
Use Footmuff
The soft footmuff can provide your child with a warm and comfortable environment.
27
Assemble the footmuff by following these steps.
1. Place the footmuff over the seat after unziping it, thread the shoulder harnesses, waist harnesses and crotch
harness through respective slots.
28
2. Stick the hook and loop fasteners.
29
3. Place baby into the footmuff, lock the safety buckle, and then rezip the footmuff. The assembled footmuff is
shown as
30
!
For the using method for restraint system, please refer to the relevant section in the instruction
manual.
Use Armbar
see images
31
-
34
Use Head Support
see images
35
-
36
Detach Soft Goods
see images
37
-
45
1. Follow steps
37
-
45
to detach soft goods.
2. To re-attach the soft goods please repeat the above steps in the reverse step.
!
The removed parts should be properly kept for convenient installation and use later.
Care and Maintenance
! Removable seat pad may be washed in cold water and drip-dried. No bleach. Please refer to the care label
for instructions on cleaning the fabric parts of the stroller.
! To clean stroller frame, use only household soap and warm water. No bleach or detergent. Periodically wipe
clean plastic parts with a soft damp cloth. Always dry the metal parts to prevent the formation of rust if the
stroller has come into contact with water.
! From time to time check your stroller for loose screws, worn parts, torn material or stitching. Replace or
repair the parts as needed.
! Excessive exposure to sun or heat could cause fading or warping of parts.
! If stroller becomes wet, open hood and allow to dry thoroughly before storing.
! If wheels squeak, use a light oil (e.g., Silicon Spray, antirust oil, or sewing machine oil). It is important to get
the oil into the axle and wheel assembly.
1
! When using your stroller at the beach, completely clean your stroller afterward to remove sand and salt from
mechanisms and wheel assemblies.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
