EasyManua.ls Logo

Joie every stage - Baby Mode Installation; Adjusting Recline Angle for Baby Mode; Installing the Child Restraint; Securing the Safety Belts

Joie every stage
99 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
10
2. Fasten the shoulder belt in the two shoulder-belt slots at the back of the
body.
12
!
Shoulder belt must pass through the Lock-off.
13
3. While pressing the child restraint,
pull the belts to fasten the child
restraint tightly and securely.
14
!
The child restraint can not be used
if the vehicle safety belt buckle
(female buckle end) is too long to
anchor the child restraint securely.
!
Please check by moving the child
restraint back and forth.
Baby Mode
(Rearward Facing Mode/for Child under 18kg /
Newborn4 years old)
see images
10
-
19
!
Please install the child restraint on the rear vehicle seat, and then put the
child in the child restraint.
i. Installation for Baby Mode
!
First adjust the angle of the child restraint to the position 5. Angle
indication: With top triangle and blue triangle aligned.
!
Make sure the shoulder harness is adjusted to proper height before
installing this child restraint.
!
When installing and adjusting the safety belts, make sure that both the
shoulder belt and the waist belt are not twisted and will not stop the safety
belts from functioning properly.
1. Pass the waist belt over seat slots, and then engage the vehicle buckle
tongue into the buckle.
10
11
12
2
1
14
11
10
13
1
2
3

Related product manuals