EasyManuals Logo

Jomox Xbase 09 User Manual

Jomox Xbase 09
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
XBase 09 Operating Manual Page 25
NOTE: If you want to shift some steps by -1 and other steps by 2, perform the -1 shift by pressing
ENTER and then perform the 2 shift in a second pass by calling up the shuffle function again,
making the settings and confriming these by pressing ENTER again.
6.4.7 Realtime Write
Realtime Write lets you record the Xbase09's instruments in real time.
Activate the Real Time Write function by pressing SHIFT and Real Time Write. Both buttons
will start blinking.
The display now reads "rEC". Press ENTER. The WRITE LED and the "rEC" display will begin
to blink.
Start the sequencer. You will hear the sound of the metronome playing 1/4 notes. Now play the
instrument buttons. The metronome is automatically switched off after the sequencer has been
stopped.
Confrim your recording by pressing ENTER or abort by pressing SHIFT.
6.4.8 Metronome
Press SHIFT and Metronome to turn the Metronome On or Off.
A click is running through Mix out all the time.
6.4.9 Hihat Sample select
Selects samples for the Closed Hihat and Open Hihat buttons.
Press SHIFT and HH Sample select. Use the UP/DOWN buttons to choose one of the following
settings that are shown in the display:
HH: The step buttons indicate which steps are assigned to the hihat sample. The default setting is:
“All steps”.
CLP: The step buttons indicate which steps are assigned to the rim shot or the clap sample
CrH: The step buttons indicate which steps are assigned to the crash cymbal sample
rid: The step buttons indicate which steps are assigned to the ride cymbal sample
noi: The step buttons indicate which steps are assigned to the noise signal.
(see also the table in the introduction, desciption of sound parameters.)
Select a sample and determine where it should sound in place of the hihat sample by pressing the
appropriate step button.
Confirm this selection by pressing ENTER. You can also select a new sample to assign and
confirm all edits with ENTER later or you can abort by pressing SHIFT.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jomox Xbase 09 and is the answer not in the manual?

Jomox Xbase 09 Specifications

General IconGeneral
BrandJomox
ModelXbase 09
CategorySynthesizer
LanguageEnglish

Related product manuals