Jomox Xbase 09 User Manual

XBase 09 Operating Manual Page 29
6.4.12 Track Page
The Track Page contents three further sequencertracks. Their data is sended out via Midi-Out
socket to control external Midi-soundgenerators directly from XBase09 internal sequencer.
Every track can have its individual Midi-channel. Notenumber and -length is adjustable for
every single step. Even accent-setting is possible.
So up to three different melodielines or chords up to three notes can be programmed.
Programming the steps is the same procedure like programming drumtracks, described in
Pattern- Mode ( chapter 6.3, P.18).
When sequencertracks are added to existing drumpatterns, the drumpatterns will not be
changed in any way.
To edit Midichannel, Notenumber and -length, the first four knobs of every instrument-section
(BD, SD, HH) have a ‘page two’-function :
1. Tune = Note 2. Pitch = Octave
3. Decay = Midichannel 4. Harmonics = Notelength
The knobs of Snaredrum- and HiHatsection are changing in the equal way.
Now, we describe the programming procedure of a sequencertrack :


 hit PATT button patternmode active LED ligths up


 hit UP/DOWN or 1-16 buttons choose pattern display shows patternnumber


 hit SHIFT,then TRACKPAGE button sequencer active display shows ‘ trC ’ for ‘track’


 hit WRITE button sequencer ‘sharp’ LED ligths up


 hit INSTRUMENT-button select track BD=1,SD=2,CH=3 LED lights up


 move knob 3 select midichannel display shows midich.-number


 move knob 4 select notelength display shows ‘ Stac ‘ or ‘ Leg ‘
-Staccato: every step is triggert
-Legato: following steps are connected
 hit STRART button sequenzer started
 set steps described in chapter 6.3 P.18
U se Induvidual Step Mode (6.3.1) to assign different notes to individual steps.
Use Track Record Mode (6.3.2 ) to assign same note to all steps. By moving knobs
1 and 2 , you can change your melodies in realtime. To get ‘musical’ results this way,
you might need some practice.
 move knob 1 and 2 assign notes and octave display shows note and trackno.
when sequencer is running and
reaching a step ‘ E - 1’
 Happy with your first track ???
 hit WRITE button Trk.Rec.Mode off LED stops flashing
 hit WRITE, then INSTRUMENTbutt. select next track
 move knob 3 select midichannel
 and so on... programm new track like above .
 Happy with all your tracks ???
 hit ENTER button pattern is stored, RampPage left

Jomox Xbase 09 Specifications

General

Brand	Jomox
Model	Xbase 09
Category	Synthesizer
Language	English