XBase 09 Operating Manual Page 27
The first five knobs of the bass drum and the snare drum control the parameters for LFO 1
and LFO 2.
LFO parameters are assigned as follows:
LFO 1 Controls (Bass Drum Controls)
Tune = LFO 1 Waveform
Pitch = Modulation target
Decay = LFO 1 Intensity
Harmonics = LFO 1 Frequency
Pulse = LFO 1 sync/free
LFO 2 Controls (Snare Drum)
Tune = LFO 2 Waveform
XSnapp = Modulation target
Decay = LFO 2 Intensity
Detune = LFO 2 Frequency
Noise Tune = LFO 2 sync/free
LFO - Waveforms
This determines the waveform generated by the LFO. Turning the knob selects the waveform. The
available waveforms are shown in the display
SuP = saw up
Sdo = saw down
tri = triangle
rCt = rectangular
LFO Modulation target
This determines the parameter the LFO will modulate. Turning the knob will select one of the
possible targets. Both LFOs can modulate one of the following parameters:
BD Pitch, Snare Tune, Xsnapp, Noise Tune, Hi Hat Tune .
Furthermore, LFO 1 can modulate LFO 2's frequency.
Modulation targets are displayed as:
bPi = Bass Drum Pitch
Stu = Snare Drum Tune
SSn = Snare Drum Xsnapp
Snt = Snare Drum Noise Tune
Htu = Hi Hat Tune
LF2 = LFO 2 Frequency (LFO 1 only)
To Next Page
Loading...
Need help?
General
