32/69
Document 10000028013-DOC-000-00-EN
we know what‘s cooking
The user must set the relevant parameters to enable the kettle to execute a program. In this example,
the following parameters must be set:
• When the process should start?
• How much water should be added to the kettle?
• What temperature should be set?
• What speed and stirring pattern should be used?
• Heating time at first given temperature
• Heat temperature thereafter?
• What speed and stirring pattern should be used thereafter?
A set of parameters is called a variant of the program and 10 variants can be saved for each program.
The same programs can therefore be executed with different sets of values. For example, variant num-
ber 1 could start at 05.00, add 50litres of water to the kettle and heat it to 90 ºC, for 12 minutes and there-
after at 80 ºC, while variant number 2 could start at 06.00, add 30litres of water to the kettle and heat it
to 50 ºC for 20 minutes and thereafter at 90 ºC.
Program 4 can be set up in the following table:
Example of setting up a program
If program 4 is to be setup, the procedure would be as follows:
Step Action Parameter Variant 1 Variant 2
1 Switch to heating mode
2 Pause until the required time P02.1 Time 05.00 06.00
3 Add water in required quantity P03.1 Water quantity 50 30
4 Set the set point for food temperature and
heating power
P04.1 Food temperature
P04.2 Heating power
90
9
50
1
5 Switch on heating
6 Set stirring pattern and stirring RPM.
Switch on the stirrer
P06.1 Stirring pattern
P06.2 Stirring rate
1
75
3
50
7 Pause for required time P07.1 Time 12 20
8 Set the set point for food temperature and
heating power
P08.1 Food temperature
P08.2 Heating power
80
7
90
9
9 Adjust new stirring pattern and stirring RPM.
Switch on the stirrer
P09.1 Stirring pattern
P09.2 Stirring rate
30
2
20
3
Step Action Parameter
1 Switch to heating mode
2 Pause until set time is reached P02.1 Time
3 Add water in required quantity P03.1 Water quantity
4 Set the set point for food temperature and heating
power
P04.1 Food temperature
P04.2 Heating power
5 Switch on heating
6 Set stirring pattern and stirring RPM
Switch on the stirrer
P06.1 Stirring pattern
P06.2 Stirring rate
If stirring pattern 0 is selected, this
step will be skipped.
7 Pause for required time P07.1 Time
To Next Page
Loading...
