English – 29
Cold engine
Chain brake:
Activate the chain brake by
pushing the front hand guard
forward.
STOP SWITCH (A):
Set the stop switch to its run
position.
CHOKE (B):
Pull the choke control fully
out.
FUEL PUMP (C):
When starting from cold: use
the fuel pump to pump fuel
into the carburettor.
First pump until the fuel can
be seen in the pump.
Then give the pump two more
strokes.
START THROTTLE:
Keep the start throttle pressed
in.
Press the start throttle lock.
Let go of the throttle while
keeping the start throttle lock
pressed in.
The throttle is held in the start
throttle position until the
throttle is pressed in again.
Warm engine
Use the same starting
procedure as for a cold
engine, with the following
exceptions:
• Slide the control to its rear
position.
• Slide the control back to its
middle position (operating
position).
Start
Activate the chain brake by
pushing the front hand guard
forward.
Grip the front handle with your
left hand and hold the saw
down by putting your right foot
in the rear handle. Pull the
starter handle with your right
hand and pull out the starter
cord slowly until the starter
pawls engage. Then pull
sharply.
Push the choke control in
when the engine fires and
keep trying again until the
engine starts.
When the engine starts,
quickly apply full throttle to
automatically disengage fast
idle.
Disengage the chain brake by
pulling the front hand guard
backwards.
CAUTION! Do not release the
starter handle from fully pulled
out position as this can cause
damage on the saw.
Start and stop
WARNING!
• Never start the saw engine without the bar, chain and
clutch cover (chain brake) assembled - or else the
clutch can come loose and cause personal injuries.
• Always move the saw away from the fueling area
before starting.
• Place the saw on clear ground and make sure that the
chain is not contacting anything. Also, make sure that
you have a secure footing.
• Keep people and animals well away from the working
area.
!
START AND STOP
!
Warning!
Never start the saw without first activating the
chain brake!
Stop
The engine is stopped by
setting the stop switch to its
“STOP” position.
C
B
A
STOP
STOP
STOP
To Next Page
Loading...
Need help?
General
