English – 39
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply
with low kickback performance requirements. However, for these models we recommend the following cutting equipment.
Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding
bar, see the table below.
Saw chain filing and file gauges
Bar Chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
16 3/8 1,5 11T Jonsered H42 60
18 3/8 1,5 11T Jonsered H42 68
20 3/8 1,5 11T Jonsered H42 72
24 3/8 1,5 11T Jonsered H42 84
28 3/8 1,5 11T Jonsered H42 92
0,050"/1,3 mm H46 H47
0,058"/1,5 mm H42 H48
!
WARNING! This chain saw model is capable of severe kickback that could result in serious
injuries to the user. Do not operate this saw unless you have extraordinary cutting needs and
experience and specialized training for dealing with kickback. Saws with significantly reduced
kickback potential are available. Always use the safest saw and cutting equipment applicable to
your cutting need.