Jonsered CS 2186 - Contents; Table of Contents

English – 3
CONTENTS
Contents
KEY TO SYMBOLS
Symbols on the machine: .............................................. 2
Symbols in the operator’s manual: ................................ 2
CONTENTS
Contents ....................................................................... 3
INTR ODUCTION
Dear Customer , ............................................................. 4
WHA T IS WHAT?
What is what on the chain sa w? ................................... 5
GENERAL SAFETY PRECA UTIONS
Bef ore using a new chain saw ...................................... 6
Important ....................................................................... 6
Always use common sense .......................................... 6
Personal protective equipment ...................................... 7
Machine ′ s safety equipment ......................................... 7
Cutting equipment ......................................................... 10
ASSEMBL Y
Fitting the bar and chain ............................................... 16
FUEL HANDLING
Fuel ............................................................................... 17
ST ARTING AND STOPPING
Star ting and stopping .................................................... 19
W ORKING TECHNIQUES
Bef ore use: .................................................................... 21
General working instructions ........................................ 21
How to avoid kickback ................................................... 28
MAINTENANCE
Carb urettor adjustment ................................................. 29
Carburettor with movement limiters .............................. 29
Carburettor without movement limiters ......................... 30
Checking, maintaining and servicing chain saw safety
equipment ..................................................................... 31
Muffler ........................................................................... 33
Starter ........................................................................... 33
Air filter .......................................................................... 34
Spark plug ..................................................................... 35
Lubricating the bar tip sprocket ..................................... 35
Needle bearing lubrication ............................................ 35
Adjustment of the oil pump ........................................... 35
Cooling system ............................................................. 35
Centrifugal cleaning “Turbo” .......................................... 36
Winter use ..................................................................... 36
Heated handles ............................................................. 36
Maintenance schedule .................................................. 37
TECHNICAL D ATA
T echnical data ............................................................... 38
Bar and chain combinations ......................................... 39
Saw chain filing and file gauges .................................... 39
EC-declaration of conformity ......................................... 39