TE: Make sure unit is assembled cor-
rectly as shown in this manual.
Fittin g the J-handle
S Position the handle on the shaft leaning
towards the engine. Note that the handle
must be mounted between the two arrows
on the shaft.
S Fit the screw, securing plate and wing nut
as shown in the diagram.
S Make a final adjustment of the J--handle
to a comfortable working position.
Tighten the wing nut.
W ARNING: Only grass blades/
grass cutters or trimmer heads/plastic
blades may be used when the
J--handle is fitted. Saw blades must
never be used with the J--handle.
S Push the attachment into the coupling until
the attachm ent snaps into place.
S Before using the unit, tighten the knob se-
curely.
B
A
Dismantling:
S Loosen the coupling by turning the knob
(at least three times).
S Push a nd hold th e b utton (C). While
securely holding the engine end, pull the
attachment straight out of the coupling.
C
Fitting the harness
Proper harness and handlebar adjust-
ments must be made with the engine com-
pletely stopped before using unit.
W ARNING: When using a
brushcutter , it must always be
hooked securely to the harness.
Otherwise, you will be unable to
control the brushcutter safely.
This can result in injury to yourself
or others.
To Next Page
Loading...
