EasyManuals Logo

Joovy Scooter X2 User Manual

Joovy Scooter X2
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Scooter X2 Instruction Manual
Page 5
7 Seatback Positioning
Each seatback can be adjusted to any position from fully
upright to reclining. These seats should only be used
for children who are at least 3 months old. For children
between 3 and 6 months, use the most reclined position.
For children 6 months and older, use the more upright
positions.
Engage the rear wheel brakes.
Locate the recline mechanism on the backside of the
seat.
To recline a seat, grasp the buttons on the top and
bottom of the recline mechanism and gently pull
towards the rear of the stroller until the seat is in the
desired position. See Figure 7.1.
To adjust a seatback to a more upright position, pull the
straps at the end of the recline mechanism rearward
while pushing the mechanism forward until the seatback
is in the desired position. See Figure 7.2.
NOTE: To get a seatback into its most upright position
you may need to push the seatback toward the front of
the stroller before pulling the straps.
!
WARNING
ALWAYS ensure that the seat back is secured into position before placing a child in the seat.
Push down on the seatback to be sure it is secure. NEVER adjust the seatback when the
child is in the seat. Use the more upright seatback positions ONLY for children who are at
least 6 months old.
8 Adjusting the Leg Supports
The leg support can be adjusted to two positions horizontal or all the way down.
To place the leg support into the down position, locate the trigger mechanism underneath BOTH sides
of the leg support on the bottom. Squeeze BOTH triggers and rotate the leg support down.
See Figure 8.1.
NOTE: The leg support does not “lock” into the down position, but will remain there by gravity only.
There are fabric aps that cover the triggers. If necessary, pull each ap over the trigger and attach
the Velcro® to secure it.
To place the leg support into the horizontal position, pull up on both sides of the leg support until it is
locked into position. See Figure 8.2.
Push down on both sides of the leg support to ensure it is secure.
Figure 7.1
Figure 7.2
!
WARNING
NEVER allow a child to step onto or sit on the leg support. This may cause the stroller to tip
over and injure the child.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Joovy Scooter X2 and is the answer not in the manual?

Joovy Scooter X2 Specifications

General IconGeneral
Stroller TypeDouble stroller
Harness Type5-point harness
Number of Seats2
Frame MaterialAluminum
Parent Cup HolderYes
Child TrayNo
Weight Capacity90 lbs
Stroller Weight32 lbs
CanopyYes, with peek-a-boo windows
StorageLarge basket underneath
Weight Capacity (per seat)45 lbs
Seat Width12.5"
Seat Depth10 inches
Recline PositionsAdjustable, near flat
Wheel Size7" front, 9.5" rear

Related product manuals