Page 6
Figure 8.2
Figure 8.1
9 Installing/Removing the
Bumper Bar
• Remove the two safety caps from the frame mount
points by pressing the release button and pulling each
cap off. See Figure 9.1.
• Locate the bumper bar and orient it with the male tting
pointed towards the seat unit and the shiny round rivet
head facing upward. While holding the male ttings
straight, insert the male ttings on the bumper bar into
the female ttings located on both sides of the seat.
You will hear both sides of the bumper bar “click” in.
See Figure 9.2.
• Pull outward on the bumper bar to ensure it is installed
properly and securely.
• To remove the bumper bar, press the buttons located
on the underside of both male ttings inward and pull
the bumper bar away from the seat. See Figure 9.3.
• The bumper bar fabric cover can be removed for
cleaning. To remove the fabric cover, simply open the
zipper on the inside of the fabric cover and pull the
cover off of the bumper bar.
• To replace the cover, remove the bumper bar from the
stroller, t the cover over the bumper bar with the zipper
facing inward and close the zipper completely.
• When using the stroller without the bumper bar always
replace the safety caps.
!
WARNING
The bumper bar is not a restraint device. Always secure your child with the seat belt. NEVER
lift the stroller by the bumper bar. Use caution when attaching the bumper bar when there is
a child seated in the stroller.
Figure 9.1
Figure 9.3
Figure 9.2
To Next Page
Loading...
Need help?
General
